The Food safe version of ProSoft® PUL, now rebranded as ProSoft FoodSAFE® PUL, meets the requirements of 21 CFR 175.300 and “may be safely used as the food-contact surface of articles intended for use in producing, manufacturing, packing, processing, preparing, treating, packaging, transporting, or holding food”.
It has also been tested as per the test methods listed in 21 CFR 175.300 for repeated use storage of food items. We did not have a container/package design for testing, and we wanted to see what types of food it would be safe for. So the entire fabric was selected for testing, and the test parameters were chosen to represent all food types and the most severe temperature/time conditions in the method. Tests were performed in the USA at an FDA approved laboratory.
The PUL passed the extreme test conditions for all types of food and drinks (not tested for alcoholic beverages) and therefore is considered safe to use for the types of food that will fall into the categories as shown below, which pretty much means everything except alcohol.
A. Types of Food covered:
I. Nonacid (pH above 5.0), aqueous products; may contain salt or sugar or both and including oil-in-water emulsions of low- or high-fat content.
II. Acidic (pH 5.0 or below), aqueous products; may contain salt or sugar or both and including oil-in-water emulsions of low- or high-fat content.
III. Aqueous, acid or nonacid products containing free oil or fat; may contain salt, and including water-in-oil emulsions of low- or high-fat content.
IV. Dairy products and modifications: A. Water-in-oil emulsion, high- or low-fat. B. Oil-in-water emulsion, high- or low-fat.
V. Low moisture fats and oils.
VIB. Nonalcoholic Beverages (VIA. – Alcoholic beverages were not tested for)
VII. Bakery products.
VIII. Dry solids. This list is very comprehensive and covers all types of food and beverages excluding alcohol.
B. Packing and storage conditions
Testing was done using the severest time/temp exaggerations ”simulating high-temperature heat sterilization” for aqueous food and fatty foods – all the types mentioned in Section A, and that actually covers all types of food and drinks except alcoholic beverages.
The items can be filled in the container under any of the following conditions:
A. Filled in the container and heat-sterilized at high temperature (e.g., over 212 deg. F) in the container
B. Filled in container and sterilized by boiling water
C. Hot filled or pasteurized above 150 deg. F in the container
D. Hot filled or pasteurized below 150 deg. F in the container
E. Filled at room temperature and stored (no thermal treatment in the container)
F. Filled and stored in Refrigerated storage (no thermal treatment in the container)
G. Stored in Frozen storage (no thermal treatment in the container)
H. Frozen storage: Ready-prepared foods intended to be reheated in container at time of use:
1. Aqueous or oil in water emulsion of high or low fat
2. Aqueous, high or low free oil or fat
The PUL passed all the test parameters under the severest conditions of temperature and time for repeated use processing, packing and storage for all types of food making it an ideal choice for using in food processing and storage applications.
Some typical uses could be: Lining food counters, food conveyor belts, baked goods shelves, pastry cloth, rolling out dough, steaming rice, food bag liners, beverage pouches, sauce bags, food storage bags, produce storage, freezer bags, unpaper plates (esp.knowing that paper plates may be laced with PFAS), pizza box liners, table mats, table cloths, transferring hot baked goods, soup bags, grocery bags etc.
What are you using FoodSAFE PUL for? Share you comments below or share your Story here.